Allied Telesis RAPIER I - Manual (Page 231)

Ethernet Protection Switching Ring (EPSR) show epsr debug 33
show epsr debug
Syntax SHOW EPSR[={epsr-name|ALL}] DEBug
Description This command show the debugging modes enabled on each EPSR instance, or
all EPSR instances (
Figure 1-15 , Table 1-4 ).
Figure 1-15: Example output from the show epsr debug command
Related Commands show epsr
Parameter Description
EPSR The EPSR instance whose debugging details are displayed.
Default: all
epsr-name The name of the EPSR instance. This can be a character
string, 1 to 15 characters long. Valid characters are
uppercase letters (A-Z), lowercase letters (a-z), digits (0-9),
the underscore character ("_"), the hyphen character ("-").
The epsr-name cannot be ALL.
ALL All EPSR instances.
DEBug Displays the debugging information about the specified EPSR instance, or all
EPSR instances.
EPSR Name Enabled Debug Modes Output Timeout
--------------------------------------------------------------------------------
blue MSG,STATE Asyn 0 (16) None
red None
--------------------------------------------------------------------------------
Table 1-4: Parameters displayed in the output of the show epsr debug command
Parameter Meaning
EPSR Name The name of the EPSR instance.
Enabled Debug Modes List of debug modes that are enabled for the EPSR instance.
Possible modes are: INFO, MSG, PKT and STATE. If a no debugging
modes are enabled, the displayed output is None.
Output Output device for the EPSR instance. This is only shown when a
debug mode is enabled.
Timeout Time in seconds that the EPSR instance stays in debug mode. This
is only shown when a debug mode is enabled. If no timeout value
has been set, the displayed output is None.
The timeout parameter is set using the
enable epsr debug
command on page 1-24