Allied Telesis RAPIER I - Manual (Page 97)

Software Version 2.8.1 97
Software Version 2.8.1
C613-10477-00 REV B
debugging is set with the detail parameter, but the output always contains the
direction of the packet, the type of packet, the version of OSPF, the packet’s
source and destination, the router ID, area, length, checksum and
authentication type. If redistribute is specified, route redistribution debugging
is enabled. If spf is specified, debugging for the Shortest Path First routing
calculations is enabled. If state is specified, both interface and neighbour state
debugging are enabled.
set ospf
Syntax SET OSPF [ASExternal={ON|OFF|NSSA}]
[BGPFilter={0..999|NONE}]
[BGPImport={ON|OFF|True|False|YES|NO}]
[BGPLimit=1..4000] [AUTOCOST={ON|OFF}]
[DEFRoute={ON|OFF|True|False|YES|NO}]
[DYNInterface={STUB|ASExternal|NONE|NO|OFF|False}]
[INRoutemap={routemap|NONE}] [METRIC=0..16777215]
[PASSiveinterfacedefault={ON|OFF|True|False|YES|NO}]
[REFBANDWIDTH=10..10000] [RIP={OFF|EXport|IMport|BOTH}]
[ROuterid=ipadd] [PTPStub={ON|OFF|YES|NO|True|False}]
[STATicexport=(YES|NO)] [TYPE={1|2}]
where:
■ ipadd is an IP address in dotted decimal notation
■ routemap is the name of an IP route map
Description No parameters or options have changed. However the behaviour of some
parameters has changed:
■ For compatibility, the asexternal, bgpimport, rip, and staticexport
parameters are synchronised with the equivalent redistribution definition.
Changing the setting of these parameters will add or delete the
corresponding route redistribution definition. Similarly, adding or deleting
a route redistribution definition changes the setting of the corresponding
bgpimport
, rip, or staticexport parameter.
■ The asexternal parameter no longer imports and redistributes non-OSPF
interface routes.