Allied Telesis RAPIER I - Manual (Page 95)

Software Version 2.8.1 95
Software Version 2.8.1
C613-10477-00 REV B
add ospf interface
Syntax ADD OSPF INTerface=interface AREa={BAckbone|area-number}
[AUthentication={AREadefault|NONE|PASSword|MD5}]
[BOOST1=0..1023] [DEadinterval=2..2147483647]
[DEMand={ON|OFF|YES|NO|True|False}]
[HEllointerval=1..65535]
[NETwork={BROadcast|NON-broadcast}]
[PASSIve={ON|OFF|YES|NO|True|False}]
[PASSword={NONE|password}] [POLLInterval=1..2147483647]
[PRIOrity=0..255] [RXmtinterval=1..3600]
[TRansitdelay=1..3600] [VIrtuallink=router-id]
Description The password parameter specifies the password used for authentication. A
password is required if the authentication scheme for the area has been set to
password
by using the add ospf area or the set ospf area commands. If none is
specified, no password is configured on the interface. The default is none.
add ospf redistribute
Syntax ADD OSPF REDistribute PROTocol={BGP|INTerface|RIP|STAtic}
[LIMit=1..4000] [METric={0..16777214|ORiginal}]
[ROUTEMap=routemap] [SUBNET={ON|OFF|YES|NO|True|False}]
[TAG={1..65535|ORiginal}] [TYpe={1|2|ORiginal}]
where routemap is the name of an IP route map
Description The modified protocol parameter specifies the type of route to redistribute.
Specify bgp or rip to redistribute routes derived from BGP or RIP, respectively.
Specify interface to redistribute non-OSPF interface routes. Specify static to
redistribute statically configured routes.
The new limit parameter specifies the maximum number of routes that can be
redistributed into OSPF for the specified protocol. The default is 1000. If you
add a BGP redistribution definition, the limit parameter overwrites the setting
of the bgplimit parameter in the
set ospf command on page 97 .
The modified metric parameter specifies the route metric that OSPF assigns to
routes that it redistributes. If you specify original, the original route metric is
preserved in the redistributed route—metric1 for Type-1 routes or metric2 for
Type-2 routes. If you assign a route map that sets the metric, the route map
overrides the setting in this parameter. The default is 20.
The modified tag parameter specifies a number OSPF uses to label routes that
it redistributes. If you specify original, the original route tag is preserved in the
redistributed route. If you assign a route map that sets the tag, the route map
overrides the setting in this parameter. The default is original.
The modified type parameter specifies the OSPF external route type that OSPF
assigns to routes that it redistributes. Use the type parameter to ensure that all
externally-sourced OSPF routes are the same type and therefore use the same
method to calculate route metrics. Specify 1 if you require the routes to have a
Type-1 external metric, or 2 if you require the routes to have a Type-2 external
metric. If you assign a route map that sets the type, the route map overrides the
setting in this parameter. The default is 2.