GW Instek GDS-200 Series User Manual - Manual (Page 18)

GDS-200 & GDS-300 Series User Manual
18
Interface Panel
Power input
for options Calibration
output
Power
switch
Internal use ports
(restricted access) USB device port
12V input port
Power Switch Power switch to turn the unit on or
off.
DC input. This port is used for
charging the internal lithium
battery. Accepts power from the
supplied AC-DC power adapter.
Input Voltage: 10.5V - 13.5V
Input Current: At least 3.5A.
USB Device Port Mini-B USB device port. This port is
used access the internal 120MB
flash memory. When connected to a
PC, the GDS-200/300 will be
recognized as an external hard disk.
Calibration Port The calibration port is used to
output a 2Vpk-pk 1kHz square
wave for probe calibration
purposes.
Internal Use Port This panel houses two ports that are
for internal use only. Use of these
ports are restricted and not for end-
user use.