GW Instek GDS-200 Series User Manual - Manual (Page 171)

FAQ
171
F
AQ
• I connected the signal but it does not appear on the display.
• I want to remove the measurement or FFT results from the display.
• The waveform does not update (frozen).
• The probe waveform is distorted.
• Autoset does not catch the signal well.
• The date and time settings are not correct.
• The accuracy does not match the specification.
I connected the signal but it does not appear on the display.
Make sure you have activated the channel by accessing the vertical
menu. You can tell if the channel is activated if its channel indicator
is to the left of the graticule. See page 51 to activate a channel.
I want to remove the measurement or FFT results from the
display.
In the vertical display mode there is no way to remove the
automatic measurements from the display. However in the
horizontal display mode the automatic measurements can be
removed by pressing the M (Measure) icon in the bottom of the
display. See page 89 for further details.