GW Instek GDS-200 Series User Manual - Manual (Page 119)

OPERATION
119
Enter Sets the NoGo condition to when
the input signal stays within the
limit boundary.
Exit Sets the NoGo condition to when
the input signal exceeds the limit
boundary.
Violating 3. Press Violating to set the NoGo Action. This
setting determines the action of the scope when
the NoGo When setting is true.
Stop The waveform stops when the
conditions are violated.
Stop Beep The waveform stops and a beep
will be output when the
conditions are violated.
Continue Ignore violations and continue
to monitor the signal.
Continue Beep Output a beep when a violation
occurs, but continue to monitor
the signal.
Turn Go-NoGo
On 4. Press Go-NoGo and turn Go-NoGo on.
An upper and lower template will appear on
the display as Ref1 and Ref2, respectively.
The Template Edit option will now be available
in the Go-NoGo menu.
Template Edit 5. The Template Edit option configures the upper
and lower template based on the source
channel selected above.
6. Select either the Max/Min or the Auto option