Micromod MOD: Modcell 2050R Users Guide - Manual (Page 11)

IB-23C650
INSTALLATION
INSTALLATION
GENERAL
Read these instructions thoroughly before starting installation. Installation
personnel should be qualified technicians. Observe all electrical code
requirements and safety standards during installation.
Installing the controller
involves:
• Unpacking
• Mounting
• Wiring Connections
Displays and Cleaning
The display is protected by an overlay that can be removed after installation.
The face of the display, while made of scratch-resistant plastic, can be
abraded by harsh materials such as paper towels and industrial wipes. Lens
cleaning tissues and soft cloths are suitable for cleaning displays. Remove
dust from the rear of the instrument by removing it from the instrument
housing and spraying exposed surfaces with non-corrosive, non-toxic, non-
flammable inert dusting gas.
Environmental Specifications
Operating Tempearture: 0 to +50°C (32 to 122°F)
Storage Temperature: –40 and+75°C (–40 and 167°F)
Humidity 5 to 95 % RH, non condensing
Altitude: 2000 meters max
Ingress Protection: (NEMA 4x) Front: IP56 Rear: IP20
Pollution degree: 2
UNPACKING
Visually inspect the controller after unpacking for any damage. A cold junction
compensating thermistor is included in the information package (an additional
one is included if the additional input option is ordered). Save packing
materials for any reshipment, or to support any claim of shipment damage. All
damage claims are made against the carrier and are the responsibility of the
customer.
5