Micromod MOD: Modcell 2050R Users Guide - Manual (Page 47)

IB-23C650
SETUP
Table 1. Base Configuration
Middle
Display
Bottom
Display
Entry Description
ENABLE NO
YES
= Don’t allow TOTALIZE **MENU** setup or
TOT variable select display.
= Allow totalizer setup and display.
ENABLE NO
YES
= Don’t allow RS-485 **MENU** setup and
display.
= Allow RS-485 **MENU** setup and display.
PASSWORD xxxx Use this value (1 to 30000) at CFG/TUNE
PASSWORD in ‘Displays’ menu to allow read
access to all menus and tune access to ‘Tune’
through ‘Setpts’ menus (a configuration
password must also be configured).
Note: value can only be viewed and changed if
you have read/write access with configuration
password. Otherwise it is shown as 0.
PASSWORD xxxx Use this value (1 to 30000) at CFG/TUNE
PASSWORD in ‘Displays’ menu to allow
complete access to all menus.
Note: value can only be viewed and changed if
you have read/write access with configuration
password. Otherwise it is shown as 0.
DATABASE YES
NO
= Checksum the data base.
= Don’t checksum the data base.
You can turn off the checksum if directed by a
service representative. A bad checksum
should not occur. If it does, some part of the
code may be corrupt.
SURE? YES
NO
This step is present only to guard against
accidentally turning off the database
checksumming.
41