beautypg.com

Memory clear debug procedures – Gasboy CFN III V3.6 and Later User Manual

Page 99

background image

MDE-4739A CFN III PCI Secure Controller Software Installation/Upgrade Instructions · July 2010

Page K-5

Correcting SC3 Board Set Problems

Memory Clear Debug Procedures

Several memory clear procedures are possible and are listed below. Use of these commands
will clear all information from the CFN III memory. To perform a memory clear, proceed as
follows:

1

Set memory board S1 switch for debug mode.

2

Set memory board S2 switch for debug mode.

3

Remove SC3 CPU board K4.

4

Enter the Dbug Mode as in

“Preparing Before Entering Dbug Mode”

on

page K-3

. At the

prompt “>> >>---..”

5

Preform any of the procedures below to complete Dbug memory clear.

Note: All data and configuration information will be written over with 0’s.

Procedure 1
“!”(! Equals SHIFT+1) Will test all memory address and set to 0’s. Process takes about
20 minutes. The test will run from A00 to D0F. It is very important to wait until the screen
displays D0F to fully complete the test and clear the memory.

Procedure 2
Enter F 1000,1000000,00 press Enter and then enter F 1000000,1FFFFF,0 press Enter. This
process takes just a few seconds each.

Procedure 3
Enter F 100,FFFFF,0 and press Enter and then enter F 0,100,0 press Enter. This process
takes just a few seconds each. However the second entry causes a reboot as it clears the Dbug
process space.