Backup file location, Cfn iii backup files by folder location, Profit point backup files by folder location – Gasboy CFN III V3.6 and Later User Manual
Page 24: Labeling the floppy disks, Backup file location labeling the floppy disks

Installation
Floppy Disk Backup
Page 18
MDE-4739A CFN III PCI Secure Controller Software Installation/Upgrade Instructions · July 2010
Backup File Location
CFN III Backup Files by Folder Location
C:\SC3
C:\SC3\BIN
C:\SC3\XBIN
C:\SC3\REPORTS
FRAMOS.CFG
SYSBACK.DTA
TRANBACK.DTA
LOOKUP.DTA
LOCKOUTN.DTA
LOCKOUTP.DTA
OFFROAD.DTA
DAY.FMT
SHIFT.FMT
PRNTRPT.CMD
Copy the entire
directory and all files.
ALL .VAR FILES
All CUSTOM.CMD
Files created for
customer and stored
in this directory
All CUSTOM.CMD files
created for customer and
stored in this directory
Compress all files. See
command to compress and
copy from reports directory
to a floppy.
Profit Point Backup Files by Folder Location
C:\POS
C:\BIN
MASTER.PLU
CONFIG.POS
KEY_LAY.POS
CUST.DTA
PATRON.LST
POSEXEC.BAT
Labeling the Floppy Disks
You will require one to seven blank formatted floppy disks to proceed, which must be labeled.
SC3
The files listed below for C:\SC3, C:\SC3\bin, the entire C:\Xbin directory, and Network
backup file created must be copied to this disk.
Profit Point (1)
The files listed below for C:\POS and C:\Bin must be copied to this disk.
Reports Directory
The *.Var files and the *.zip file for the reports directory will be copied to this disk. Reports
saved from CFN III running version 3.4 or earlier software must not be restored to a
version 3.6 or later, PCI-compliant tower. It is intended for customer backup only.
Note: This process may take more than one floppy.
Command Files
Place all discovered custom command files on this disk.
Note: Additional disks can be used for Profit Point 2, 3, and 4 if they differ from Profit
Point 1.