Gasboy CFN III V3.6 and Later User Manual
Page 39

MDE-4739A CFN III PCI Secure Controller Software Installation/Upgrade Instructions · July 2010
Page 33
Installing the Windows XPE OS Image
Installation
c
Click the COM port to be modified.
d
Click Properties from the menu box.
e
Click the Port Settings tab on the Window that opens.
f
Click Advanced.
g
At the bottom left of the “Advanced settings for COM(X)” window will show the current
(Example)“COM7” with a drop down arrow. Click the “arrow” and select the correct COM
port assignment.
h
Verify and or set the FIFO Receive buffer to “1” and Transmit buffer to “1”.
Notes: 1) FIFO must be verified and set for every COM port used for PC Loop
Applications.
2) For additional information and resolutions for devices, refer to
Application: Hardware, Software, Port, and Communication Wiring”
25
It is advised to “Restart Windows XPE” on more time to verify Windows XPE has found all
devices and setup all configurations properly. (Start/Shut Down/Restart/OK) If Windows XPE
does not boot cleanly, zero error messages, an additional reboot must be performed or the issue
determined.
26
Log on again as administrator and close any open windows (refer to
).
27
If all is correct with the installation of the Windows XPE OS proceed to
the PCI-compliant CFN III and Integral Profit Point Software”
.
28
Ensure that you install the Windows XPE License Stickers and provide the customer with the
Windows XPE license envelope for safekeeping. For detailed instructions, refer to
on
.