Terms used, Installing/upgrading, Important information – Gasboy CFN III V3.6 and Later User Manual
Page 40
Installation
Installing/Upgrading the PCI-compliant CFN III and Integral Profit Point Software
Page 34
MDE-4739A CFN III PCI Secure Controller Software Installation/Upgrade Instructions · July 2010
Installing/Upgrading the PCI-compliant CFN III and Integral
Profit Point Software
You must have completed both the
and the
. Do not proceed with an upgrade to version 3.6
or later if these two procedures have not been completed
IMPORTANT INFORMATION
The site has closed.
All sales are completed and receipts have been printed.
The STOP command has been issued to prevent any new sales.
Shift and Day close processes are completed and reports printed.
All transactions have been polled from the site (if applicable).
The network settlement has been completed and verified.
Perform a SYSBACK and TRANBACK.
Terms Used
Note: The terms apply to both the CFN III and the Profit Point software.
Term
Description
Upgrade
• It is the process of upgrading from a PCI-complaint version to a newer PCI-complaint
version, for example, version 3.6 to 3.6A.
• An upgrade from version 3.6 without a reimage to Windows XPE is also an upgrade
procedure, for example, 3.5 to 3.5A or 3.5 to 3.6 release version.
• If you are upgrading from a version earlier than version 3.6, perform a New Installation
process. Reimage with Windows XPE and perform a new install of the current version of
version 3.6.
New Install
When you reimage the tower to Windows XPE and perform a fresh install of the current
release. The Floppy Disk backup procedure must be completed before a reimage of the tower.