EXFO AXS-200/850 Ethernet Test Set - Manual (Page 38)

Configuring and Starting a Test or Tool
28 AXS-200/850
Configuring a BERT Test
Configuring a BERT Test
To configure the BERT test:
1. Configure the interface by configuring the port, network, and VLAN
settings. Refer to Interface on page 33. Ensure that the link is up
(indicated by the platform LED) before proceeding to the next step.
2. Optionally, set a remote module in loopback. Refer to Remote
Selection on page 45.
3. Press , select BERT, Configuration, and the Global tab.
4. Configure the global settings by referring to Global Configuration on
page 97.
5. Select the Stream tab.
6. Configure the stream by referring to Stream Configuration on page 101.
7. Press to start or stop the test.