EXFO AXS-200/850 Ethernet Test Set - Manual (Page 141)

Traffic Generation & Monitoring
Ethernet Test Set 131
Stream Configuration
When enabled, a Neighbor Solicitation request is sent to the network
to retrieve the MAC Address corresponding to the selected IP address
for IPv6.
If not resolved after 3 seconds, it gives status as Failed. If the MAC
address is resolved then the status is displayed as Resolved. The status
field also displays “--” when the Resolve MAC Address is disabled, and
other status includes Failed, Not Resolved, and Resolved. The default
status is “--”.
³
Destination IP Address: Enter the Destination IP Address.
The default setting for IPv4 is 10.10.0.0, or is set automatically to the IP
address of the target module that is looped up from Remote Loopback
mode. The destination IP address can be configured in
Ethernet/IPv4/UDP mode.
The default setting for IPv6 is
2001:0000:0000:0000:0000:0000:0000:0000, or is set automatically to
the IP address of the target module that is looped up from Remote
Loopback mode. The destination IP address can be configured in
Ethernet/IPv6/UDP mode.
The accepted range for IPv4 is 0.0.0.0 to 255.255.255.255. The default
value is 0.0.0.0.
The IPv6 Address can either be the Link-Local IPv6 Address or the
Global IPv6 Address.
The acceptable range for IPv6 is from
000:0000:0000:0000:0000:0000:0000:0001 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF.
³
Quick Ping: Select the Quick Ping button to test if the destination
IP address can be reached. A message will be returned to indicate
if the ping attempt was Successful or Failed.
Note: When a remote module is looped up, the Destination IP Address is not
configurable (read only). When a remote module is looped down, the
Destination IP Address reverts to the previously configured value.