EXFO AXS-200/850 Ethernet Test Set - Manual (Page 153)

Traffic Generation & Monitoring
Ethernet Test Set 143
Stream Configuration
³
Resolve MAC Address: Enable or disable Resolve MAC Address. The
default setting is Disabled.
When enabled, an ARP request is sent to the network to retrieve the
MAC Address corresponding to the selected IP address for IPv4.
When enabled, a Neighbor Solicitation request is sent to the network
to retrieve the MAC Address corresponding to the selected IP address
for IPv6.
If not resolved after 3 seconds, it gives status as Failed. If the MAC
address is resolved then the status is displayed as Resolved. The status
field also displays “--” when the Resolve MAC Address is disabled, and
other status includes Failed, Not Resolved, and Resolved. The default
status is “--”.
³
Destination IP Address: Configure the destination IP address in the
Destination IP Address field.
The default setting for IPv4 is 10.10.0.0 or is set automatically to the IP
address of the target module from the Remote Loopback mode. The
destination IP address is configured only when Ethernet/IPv4/UDP is
selected.
The default setting for IPv6 is
2001:0000:0000:0000:0000:0000:0000:0000 or is set automatically to
the IP address of the target module from the Remote Loopback mode.
The destination IP address is configured only when Ethernet/IPv6/UDP
is selected.
The accepted range for IPv4 is 0.0.0.0 to 255.255.255.255. The default
value is 0.0.0.0.
The IPv6 Address can either be the Link-Local IPv6 Address or the
Global IPv6 Address.
The acceptable range for IPv6 is from
000:0000:0000:0000:0000:0000:0000:0001 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF.