TeeJet Fieldware SA 2.0 for Legacy 6000 - Manual (Page 170)

7-6 Chapter 7 - Fieldware - SA
Running Version Update on the Console
Version Update for Fieldware SA for the Legacy 6000
Finishing the Version Update
When the setup installation is complete a Setup Successful message appears (see Figure 7-5). At
this point the power must be cycled on the console. To do this press the Enter key on the console
or press the Power key on the console.
If the Repeat setup type was selected, the PC card must be removed prior to powering back on. If
the PC card is left in the console and power turned on, the version update runs again.
If the Single setup type was selected, it is not necessary to remove the PC card prior to powering
the console back up.
Figure 7-5: Setup Successful Message