TeeJet Fieldware SA 2.0 for Legacy 6000 - Manual (Page 149)

Fieldware-SA for the Legacy 6000
Software Version 2.00
Chapter 5 - Fieldware FieldPilot 5-11
Fieldware-SA Real-Time Operation
Real-time Operation
When real-time setup is complete, press the Bull’s Eye button in the real-time setup page (Figure
5-11). The Navigation page is the first page displayed (Figure 5-12). If a rate controller is being
used; the Rates page is displayed first. To move to the Map page (Figure 5-13), press the Blue
Arrow button located at the lower right corner of the page.
Setup Description
Job Report: Enter weather, soils, and field conditions. This step is optional.
ARM Setup: Enter the appropriate file names here, including for the Guideline file. File
names are automatically named based on the Job name. If auto-naming is acceptable,
this step is optional. This is where an existing Guideline file is selected, if one was cre-
ated at an earlier date and will be re-used.
Product Setup: Select the name of the product being applied. This step is optional if
product application is not being performed.
Table 5-2: Real-time Setup
Figure 5-12: The Navigation Page
Press to move to the Map Page.