TeeJet Fieldware SA 2.0 for Legacy 6000 - Manual (Page 161)

Manual Guidance Activation for Fieldware SA for the Legacy 6000
Software Version 2.00
Chapter 6 - Manual Guidance 6-3
Installing the Plug-in on the Console
Installing the Plug-in on the Console
This section describes how to install and activate the Manual Guidance plug-in on the Legacy
6000 console. There are two main steps to performing a User Update. The first step is run on the
PC or Laptop and extracts the User Update Startup Folder to the PC card or a folder location on
the computer. This document assumes that this step has already been done. The second step is to
run the Update Setup program on the Legacy 6000 console from the PC card.
The first page is the Manual Guidance Welcome page (see Figure 6-1). To continue press the
Green arrow soft-key located in the top right corner. To cancel the plug-in activation, press the Red
arrow soft-key in the top left corner.
The next page is the Ready to Activate page. Read this page over and press the Green arrow soft-
key to begin activation. To cancel out of the activation process, press the Red arrow key.
Figure 6-1: Manual Guidance Welcome Page