TeeJet Fieldware SA 2.0 for Legacy 6000 - Manual (Page 142)

5-4 Chapter 5 - Fieldware FieldPilot
Installing the Plug-in on the Console
Fieldware-SA for the Legacy 6000
Software Version 2.00
Installing the Plug-in on the Console
This section describes how to install and activate the FieldPilot plug-in on the Legacy 6000 con-
sole. There are two main steps to perform a User Update. The first step is run on a PC or Laptop
and extracts the User Update Startup Folder to a PC card or a folder location on the computer.
This document assumes that this step has already been done. The second step is to run the Leg-
acy 6000 console Update Setup program, from the PC card.
The first page that appears is the FieldPilot Welcome page (Figure 5-3). To continue, press the
Green Arrow soft-key located in the top right corner. To cancel the plug-in activation, press the Red
Arrow soft-key in the top left corner.
The next page is the Ready to Activate page. Read this page over and press the Green Arrow soft-
key to begin activation. To cancel the activation process, press the Red Arrow key.
Figure 5-3: FieldPilot Welcome Page