TeeJet Fieldware SA 2.0 for Legacy 6000 - Manual (Page 14)

2-2 Chapter 2 - Getting Started
Software Overview
Fieldware-SA for the Legacy 6000
Software Version 2.00
Software Overview
This chapter assumes that the Legacy 6000 hardware has been properly installed and clean, reli-
able power has been supplied.
Fieldware - SA Software Feature Activations
Fieldware - SA software comes with several feature activations which can be configured to meet
the job requirements. Each feature activation is described in Table 2-1. The actual activation of
features occurs at Midwest Technologies. To determine which feature activations are installed on
the console see “Console” on page 2-38.
Activation Description
Basic
The Basic package comes with the ability to perform single product rate con-
trol, manual or variable rate (VR). This activation is covered in this user’s
guide.
Manual Guidance
The Manual Guidance activation adds the ability to perform parallel, curved,
and center pivot guidance (a lightbar is required). This activation is covered in
this user’s guide.
FieldPilot
The FieldPilot activation adds the ability to perform automated steering using
Mid-Tech’s FieldPilot system. Additional hardware is required for this activa-
tion. Contact Mid-Tech for more details. This activation is covered in this user’s
guide.
Multi-Product The Multi-product activation adds the capability to apply, VR, two or more prod-
ucts. This activation is covered in this user’s guide.
Table 2-1: Fieldware Software Activation Descriptions