Lenze 8400 BaseLine C - Manual (Page 50)

4 Device control (DCTRL)
4.1 Device commands
50
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.1.4 Import EPM data
The C002/12 = "1: On / start" device command activates the automatic import of parameters from
the memory module after the error message "PS04: Par.set incompatible".
4.1.5 Enable/Inhibit controller
The C002/16 = "1: On / start" device command enables the controller, provided that no other source
of a controller inhibit is active.
The
C002/16 = "0: : On / start" device command enables the controller, provided that no other sour-
ce of a controller inhibit is active.
• The motor becomes torqueless and coasts down.
• When the controller is inhibited, the status output bCInhActive of the
LS_DriveInterface system
block is set to TRUE.
• When the controller inhibit request is reset, the drive synchronises to the actual speed. For this
purpose,
• If the flying restart circuit is activated in C990 , the flying restart function parameterised in
C991 is used for the synchronisation to the rotary or standing drive.  Flying restart function
( 94)

Tip!
• The controller can also be enabled or inhibited via the and toolbar icons.
• C158 provides a bit coded representation of all active sources/triggers of a controller in-
hibit.
4.1.6 Activate/Deactivate quick stop
The C002/17 = "1: On / start" device command activates the quick stop function, i.e. the motor con-
trol is separated from the setpoint selection, and within the deceleration time parameterised in
C105 the motor is brought to a standstill (n
act
= 0).
• A pulse inhibit (CINH) is set if the "Auto-DCB" function has been activated via C019 .
The C002/17 = "0: Off / ready" device command deactivates the quick stop again, provided that no
other source of a quick stop is active.

Tip!
C159 provides a bit coded representation of all active sources/triggers of a quick stop.
Parameter Info Lenze setting
Value Unit
C105 Deceleration time - quick stop 2.000 s