Lenze PLC Designer PLC-Designer (R2-x) SoftMotion - Manual (Page 65)

L-force | PLC Designer - SoftMotion
CNC editor
Supported and extended elements of the CNC language of DIN66025
65
L
DMS 5.2 EN 03/2011 TD17
Word identifiers
Word identifier Meaning
D Tool radius (for correction G40-42 or angle rounding G50-51), or
variable value (G36/G37)
E Max. acceleration (> 0) / deceleration (< 0) [path units/s ² ]
F Velocity at which travel is to take place [path unit/s]
G Travel command
H Activate (>0)/deactivate (<0) switching point
I X coordinate of the circle/ellipse centre (G02/G03/G08/G09), or
X coordinate of the parabola-tangent intersection
J Y coordinate of the circle/ellipse centre (G02/G03/G08/G09), or
Y coordinate of the parabola-tangent intersection
K Direction of the principle ellipse axis in the mathematical sense (0° O, 90° N, ...), or
jump condition (G20), or dT1 parameter value (M-function)
L Absolute switching point position measured from the path object start (> 0) / end (< 0), or
jump destination (G20), or dT2 parameter value (M-function)
M Additional function
O Relative switching point position [0 ... 1], variable to be changed (G36/G37), or
M-parameter data structure (M)
P Target value of additional axis P
Q Target value of additional axis Q
R Circle radius (G02/G03) (alternatively to I,J), or
length ratio of the secondary/principal axis (G08/G09) [0 ... 1]
S Switch on (>0)/switch off (< 0) S-profile for linear axes
3: Z-axis, 7: P-axis, 8: Q-axis, 9: U-axis, 10: V-axis, 11: W-axis
U Target value of additional axis U
V Target value of additional axis V
W Target value of additional axis W
X X-coordinate of target point
Y Y-coordinate of target point
Z Target value of additional axis Z