Festo Электромотор MTR-DCI - Manual (Page 78)

} Settings
}
Axis type
Axis parameter
Homing paramet.
Position set
Password edit
PB Parameter
4. The control panel (type MTR-DCI-...-H2)
4-12
Festo P.BE-MTR-DCI-PB-EN en 1209a
4.4 [Settings] menu
Warning
Injury to persons and damage to property from collisions
With all positioning procedures, the motor turns and the
connected axis moves.
• Make sure that:
– Nobody can place their hands into the positioning
range
– There are no objects within the positioning range
For parameterising the axis system and programming the
position set records:
1. Use the arrow keys to select the [Settings] item from the
main menu and press the button.
2. Select the following:
– The axis type [Axis type]
– The axis parameters [Axis param]
– The homing parameters [Homing param]
– The position set table [Position set]
– The password setting [Password]
– The PROFIBUS address [PB parameter].
Note
The parameters you have set take effect immediately upon
confirmation with OK .
• Save the parameter settings permanently in EEPROM
with the
[Save] menu command. Only then will the set-
tings be retained even if the power supply is switched
off or if there is a power failure.