Festo Электромотор MTR-DCI - Manual (Page 109)

5. Commissioning
5-21
Festo P.BE-MTR-DCI-PB-EN en 1209a
5.2.7 Setting PROFIBUS addresses
Before commissioning on the PROFIBUS, you must set a valid
station number.
– Valid station numbers: 0 ... 125.
– The invalid station number 255 is preset.
This is to make sure that a correct address is set during
commissioning or when replacing.
– Addresses cannot be assigned by the master (the service
Set_Slave_Address is not supported).
Note
Station numbers may only be assigned once per fieldbus
master.
Set the station numbers as follows:
1. Select [Settings] [PB parameter] [PROFIBUS ADR]
(see also section 4.4).
2. The current address is displayed with .
3. Set the desired address with the arrow buttons.
4. Accept the address with OK .
The set address becomes effective immediately and is
saved against network failure.
} Settings
PB parameter
PROFIBUS ADR
PROFIBUS address
7
ESC
EDIT <--> SAVE