Festo Электромотор MTR-DCI - Manual (Page 60)

3. Installation
3-12
Festo P.BE-MTR-DCI-PB-EN en 1209a
Information on commissioning and parameterising the
MTR-DCI via the serial interface can be found in chapter 5.3
and in the help system for the FCT software package.
Information on transmitting CI commands via the serial
interface can be found in appendix B.2.2.
Note
The RS232 interface is not galvanically separated. It is not
appropriate for permanent connection to PC systems, nor
for use as a control interface.
• Use this terminal only for commissioning.
• Remove the programming cable in continuous opera-
tion.
• Seal the terminal with the supplied protective cap (ISK-
M8).