Festo Электромотор MTR-DCI - Manual (Page 170)

5. Commissioning
5-82
Festo P.BE-MTR-DCI-PB-EN en 1209a
Device connection
Caution
The RS232 interface is not electrically isolated. It is not
intended for permanent connection to PC systems or as a
controller interface.
• Use the connection only for parameterising and diag-
nosis.
Controlling during operation
Warning
Danger of injury.
Faults in parameter assignment can cause injury to people
and damage to property when the controller is enabled.
• Only enable the controller once the axis system has been
installed and parameterised by technically qualified
staff.
Caution
Note the manufacturer's specifications for the permitted
operating conditions of the motors and drives used, such
as the permitted positioning speeds, for example.
Caution
Damage to components with DMES-...
Movement onto the mechanical end positions is not per-
mitted during operation. When movement is made to the
end positions with a heavy load, blockage may occur in the
end positions.
Note
Any functions implemented for the purposes of
EMERGENCY-STOP procedures must also be taken into
account in the control programs