Festo Электромотор MTR-DCI - Manual (Page 134)

5. Commissioning
5-46
Festo P.BE-MTR-DCI-PB-EN en 1209a
Description of the general status bytes
Status byte 1 (SCON)
Bit EN Description
B0
ENABLED Drive Enabled = 0: Drive blocked, controller not active
= 1: Drive (controller) enabled
B1
OPEN Operation
Enabled = 0: Stop active
= 1: Operation enabled, positioning possible
B2
WARN Warning = 0: Warning not active
= 1: Warning active
B3
FAULT Fault = 0: No fault
= 1: There is an active fault, or reaction to fault is active.
Fault number in diagnostic memory
B4
24VL Supply Voltage is Applied = 0: No load voltage
= 1: Load voltage applied
B5
LOCK Drive control by FCT/HMI = 0: Device control by PLC/fieldbus
= 1: Device control by FCT/HMI
(PLC control is locked)
B6
OPM1 Display
Operating Mode = 00: Record Select (Standard)
= 01: Direct mode
= 10: Reserved
= 11: Reserved
B7
OPM2