Festo Электромотор MTR-DCI - Manual (Page 181)

6. Diagnostics and fault display
6-9
Festo P.BE-MTR-DCI-PB-EN en 1209a
Warnings Warnings have no effect on the behaviour of the drive. The
cause of the warning should however be eliminated so that it
does not lead to a fault.
When a warning occurs, the fault LED flashes and the output
WARNING is set (FHPP status bits, SCON.B2).
Warning Cause
HOT
TEMPERATURE Operating temperature 70 °C < T < 80 °C,
may need to check whether drive is overloaded,
check the mechanical parts (e.g. for stiffness),
reduce ambient temperature.
COLD
TEMPERATURE Operating temperature < -10 °C,
increase ambient temperature as appropriate.
STANDSTILL-
WARNING The axis has moved outside the standstill
position window.
ILLEGAL
RECORD
WARNING Invalid record number.
Fault If there is a fault, the drive will be stopped. The fault LED will
flash.
1. Eliminate the cause of the fault.
2. Acknowledge the fault message:
– With on the control panel
– Via fieldbus with a falling edge on the ENABLE signal
– Via fieldbus with a rising edge on the RESET signal
CCON.B3
– With the “Reset error” button in the Festo
Configuration Tool