Allied Telesis AT-S97 - Manual (Page 98)

Chapter 5: Port and Module Commands
98
Figure 13. SYSTEM SHOW MODULE Command for a Power Supply or
Fan Module
The acronym “RPS” for “Redundant Power Supply” in the top line should
be ignored. It is a misnomer for a fan module as well as for a power supply
module in a chassis with just one power supply. The letter following “RPS”
is the chassis slot location of the power supply or fan module.
Figure 14 illustrates the information for the AT-MCF2000M Management
Module.
Figure 14. SYSTEM SHOW MODULE Command for the AT-MCF2000M
Management Module
RPSA Information:
Module Name ................
Module Type ................ AT-MCF2000AC
Power OK ................... Yes
Module Present ............. Present
3.3V ....................... Good = 3.415V
12.0V ...................... Good = 12.125V
Temperature ................ 25.821 C
Temperature Threshold ...... 60 C
Fan A Speed ................ 7105 RPM
Fan B Speed ................ 7033 RPM
CPU Information:
Name .......................
Module Type ................ AT-MCF2000M
Module Status .............. Active
Module Present ............. Present
1.2V ....................... Good = 1.212V
1.8V ....................... Good = 1.818V
2.5V ....................... Good = 2.535
3.3V ....................... Good = 3.336V
12.0V ...................... Good = 12.187
Temperature ................ 29.2500 C
Temperature Threshold ...... 60 C
Management Port:
Link State ........... Up
Auto Negotiation...... Enabled
Speed ................ 100 Mbps
Duplex ............... Full
MDI Crossover ........ MDI
Stacking Port:
Link State .......... Up