Allied Telesis AT-S97 - Manual (Page 137)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
137
Note
Do not modify existing manager accounts or add new accounts by
editing the master configuration file. Instead, use the command line
interface in the management software. You can delete accounts by
deleting the corresponding line in the file, but do not delete the
predefined manager account (i.e., NAME=MANAGER). For further
information, refer to Chapter 12, “Manager Account Commands” on
page 187.
Blade Configuration
This section controls the operating parameters of the channels and ports
on a media converter module. A master configuration file will have a
separate Blade Configuration section for each media converter module in
the chassis or stack.
The section is prefaced with three header lines that identify the media
converter module in the chassis controlled by the commands in the
section. An example is shown in Figure 27.
Figure 27. Blade Configuration Header
The Filename line identifies the name of the auxiliary configuration file
used to create that portion of the master file as well as the media converter
module controlled by the commands. The numbers in the filename identify
the module. The first number represents the chassis ID and the second
number the slot number. For example, the auxiliary configuration filename
“BM_0_2.cfg” in Figure 27 identifies the media converter module in slot 2
of the chassis with the ID number 0.
The Model Type field specifies the model name of the media converter
module and the MAC Address specifies its MAC address.
Note
The header lines of a Blade Configuration section should not be
modified or deleted.
The first subsection in a Blade Configuration is illustrated in Figure 28. It
sets the operating modes of the media converter channels on the module
with a modified version of the SYSTEM SET INTERFACE command. The
ID parameter of the command is replaced with a PORTID parameter,
which specifies the channel number. For example, PORTID=1 designates
channel 1, which on the AT-MCF2012LC and AT-MCF2012LC/1 Media
## Filename: BM_0_2.cfg
## Model Type: AT-MCF2012LC
## MAC Address: 00:15:77:70:7A:2C