Allied Telesis AT-S97 - Manual (Page 71)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
71
SYSTEM SET INTERFACE
Syntax
system set interface id= chassis / slot [/ channel ]
opmode=link-test|ml|sml
Parameters
id Specifies a media converter module or a channel. The ID
consists of the following parts:
chassis Identifies the ID number of the chassis with the
media converter module. In version 1.3.0 the
chassis ID number is 0 or 31.
slot Specifies the ID number of the slot with the
module. Possible values are:
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2.
channel Specifies the number of the channel. Possible
values are:
1 to 12 Specifies a channel on the
AT-MCF2012LC and
AT-MCF2012LC/1 Modules. Channel
1 consists of twisted pair port 1 and
fiber topic port 1, channel 2 of twisted
pair port 2 and fiber topic port 2, and
so on. You can specify only one
channel at a time. Alternatively, to
set all the channels on a media
converter module to the same
operating mode, omit this parameter.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 86 or “SYSTEM
SHOW CLUSTER” on page 88. To view the channels, refer
to “SYSTEM SHOW INTERFACE” on page 90.
opmode Specifies the operating mode for the channel. Available
settings are:
link-test Specifies the Link Test mode. This is the
default setting.