Allied Telesis AT-S97 - Manual (Page 68)

Chapter 5: Port and Module Commands
68
SYSTEM RESET MODULE
Syntax
system reset module id= chassis / slot
Parameters
id Identifies the media converter module or management
module to reset. The ID number consists of the following
parts:
chassis Identifies the ID number of the chassis with the
module to reset. In version 1.3.0 the chassis ID
number is 0 or 31.
slot Specifies the letter or ID number of the slot with
the module. Possible values are:
m Identifies the management module
slot with the AT-MCF2000M
Management Module.
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CHASSIS” on page 86 or “SYSTEM
SHOW CLUSTER” on page 88.
Privilege Levels
Administrator and read-write.
Description
This command performs a soft reset on a module in a chassis by
initializing the AT-S85 or AT-S97 Management Software. You might reset
a module if it is experiencing a problem.
Note
Resetting a media converter module may result in the loss of some
network traffic.