Allied Telesis AT-S97 - Manual (Page 51)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
51
SYSTEM SET CHASSIS
Syntax
system set chassis id= chassis name= name
Parameters
id Identifies the ID number of the chassis. In version 1.3.0, the
chassis ID number is 0 or 31. To view the ID number of a
unit, use the SYSTEM SHOW CLUSTER command. For
instructions, refer to “SYSTEM SHOW CLUSTER” on
page 88.
name Specifies a name of up to 20 alphanumeric characters for
the chassis. Spaces are permitted, but a name with spaces
must be enclosed in double quotes (“ “). To remove the
current value without specifying a new value, enter “none”.
Privilege Levels
Administrator and read-write.
Description
This command assigns a name to a chassis. Names can makes it easier to
identify the different devices. This command is different from the SYSTEM
SET HOSTNAME command in that the latter assigns a name to an entire
stack, while this command can assign names to the individual units in a
stack. To view the current name of a chassis, refer to “SYSTEM SHOW
CHASSIS” on page 86 or “SYSTEM SHOW CLUSTER” on page 88.
Examples
This command assigns the name “interconnect51” to a chassis with the ID
number 0:
system set chassis id=0 name=interconnect51
This command assigns the name “wtc connection” to a chassis with the ID
number 31:
system set chassis id=31 name="wtc connection"