Allied Telesis AT-S97 - Manual (Page 97)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
97
SYSTEM SHOW MODULE
Syntax
system show module id= chassis / slot
Parameters
id Identifies a module. You can specify only one module at a
time. The ID number consists of the following parts:
chassis Specifies the ID number of the chassis with the
module. In version 1.3.0, the chassis ID number
is 0 or 31.
slot Specifies the ID number or letter of the slot with
the module. Possible values are:
m Specifies the management module
slot.
a or b Specifies a slot letter of a power
supply or fan module. In the
AT-MCF2000 Chassis, the left slot is
A and the right slot is B when the unit
is viewed from the back.
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2 when the unit
is viewed from the front.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 88 or “SYSTEM
SHOW CHASSIS” on page 86.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays status information about the media converter,
power supply, fan, and management modules in a chassis. The
information varies depending on the module. Figure 13 is an example of
the information for the AT-MCF2000AC Power Supply Module or the
AT-MCF2FAN Fan Module.