Allied Telesis AT-S97 - Manual (Page 117)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
117
LOGGING SET EVENTLOG
Syntax
logging set eventlog severity-level=critical|major|minor|
event
Parameters
severity-level Specifies the severity level of the event messages
displayed in the event log and sent to a syslog server. The
same level applies to both the event log and the syslog
client. The levels from highest to lowest severity are:
critical Critical events signal the loss of power to or the
failure of a power module. Messages of this
level can also reflect a physical change to the
stacking feature, such as the removal of a
stacking cable or the introduction of new chassis
to a stack.
major Major events announce a component failure to
the a fan or media converter module. Resets of
and powering on a module or chassis are also
categorized as major events.
minor Minor events encompass physical changes to a
chassis, such as the installation or removal of a
module. Connecting and disconnecting cables
to the ports of the media converter channels are
also listed as minor events.
event Event messages typically signal a change in the
status of a management component, such as
the Telnet or SSH server. The start and end
points of remote Telnet and Secure Shell
management sessions and TFTP functions are
also members of this category.
Selecting a level designates the messages of that level and
all levels above it. For example, selecting the Critical level
selects only Critical event messages, while selecting the
Event level, the default setting, spans all levels and,
therefore, all event messages.
Privilege Levels
Administrator and read-write.