Allied Telesis AT-S97 - Manual (Page 134)

Chapter 8: Configuration File Commands
134
File Header Lines
At the top of the file are three lines of header information, shown in
Figure 20. These lines should never be modified or deleted.
Figure 20. Management Module Configuration Header
System Configuration
The commands in this section define general information about the
management module.
Figure 21. System Configuration Section
The section accepts the following AT-S97 Management Software
commands:
ˆ “SYSTEM SET ASYNCHRONOUS” on page 50
ˆ “SYSTEM SET CONSOLE” on page 53
ˆ “SYSTEM SET CONTACT” on page 54
ˆ “SYSTEM SET HOSTNAME” on page 55
ˆ “SYSTEM SET LOCATION” on page 56
ˆ “SYSTEM SET MODULE” on page 77
The module’s name is set with a modified version of the SYSTEM SET
MODULE command, where the MODULE keyword is replaced with
MYMODULE and the management module slot is indicated in the ID
parameter with “0” (zero) rather than “M”. This modified command also
sets the temperature thresholds of the management module and the
power supply and fan modules. The command with the slot ID of “0” (zero)
sets the temperature threshold for the management module while the
commands with the slot IDs of “A” and “B” (e.g., “0/A” and “0/B”) set this
## Filename: MM.cfg
## Model Type: AT-MCF2000M
## MAC Address: 00:15:77:70:7A:25
### System Configuration
system set asynchronous baudrate = 115200
system set console timeout=10
system set contact "none"
system set hostname "none"
system set location "none"
system set mymodule id=0/0 name="none"
system set mymodule id=0/0 temperature-threshold=60
system set mymodule id=0/a temperature-threshold=60
system set mymodule id=0/b temperature-threshold=60