Allied Telesis AT-S97 - Manual (Page 56)

Chapter 4: General System Commands
56
SYSTEM SET LOCATION
Syntax
system set location= location
Parameters
location Specifies a location of up to 25 alphanumeric characters for
the chassis or stack. Spaces are allowed, but a location
with spaces must be enclosed in double quotes (“ “). To
remove the current value without specifying a new value,
enter “none”.
Privilege Levels
Administrator and read-write.
Description
This command sets the location of the chassis or stack. This information
can be helpful in locating the different media converter units in your
network. To view the current value for this parameter, refer to “SYSTEM
SHOW INFO” on page 60.
Examples
This command sets a stack’s location to “Bldg 3, rm 212”:
system set location="Bldg 3, rm 212"
This command removes the current location without assigning a new
value:
system set location=none