Allied Telesis AT-S97 - Manual (Page 94)

Chapter 5: Port and Module Commands
94
Description of the Chassis, Slot, and Channel Command
To view the operating parameters of the channel’s two ports, including the
speeds and duplex modes, specify a channel number in the command.
You can view only one channel at a time. Figure 12 is an example of the
information.
Copper Online Both ports in the channel have
established a link with a
network device.
Fiber Online
Copper TX SML The twisted pair port of the
channel can establish a link
with its network device, but the
fiber optic port is unable to
establish a link with its remote
device.
Fiber Offline
Copper Offline The fiber optic port of a
channel can establish a link
with its network device, but the
twisted pair port is unable to
establish a link with its local
device.
Fiber TX SML
Twisted Pair
Port TX or RX
SML Both ports in the channel can
establish a link to a network
device, but one of the ports is
connected to another media
converter that also supports
the Smart MissingLink feature,
forming a chain of converters.
A link has been lost on one of
the ports in the chain, causing
a ripple affect through the
chain of converters.
Fiber Optic Port TX or RX
SML
Table 6. Port Status in the Smart MissingLink Mode (Continued)
Channel Port Status Description