Allied Telesis AT-S97 - Manual (Page 58)

Chapter 4: General System Commands
58
SYSTEM SHOW CLOCK
Syntax
system show clock
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays the current date and time of the management
module. This information is added to event messages and SNMP traps.
To manually set the date and time, use the SYSTEM SET CLOCK
command. For information, refer to “SYSTEM SET CLOCK” on page 52.
To set the date and time from an Network Time Protocol (NTP) server,
refer to Chapter 6, “Network Time Protocol Commands” on page 101.
Example
system show clock