Allied Telesis AT-S97 - Manual (Page 64)

Chapter 5: Port and Module Commands
64
SYSTEM RESET CHASSIS
Syntax
system reset chassis id= chassis
Parameters
id Identifies the ID number of the chassis to reset. In version
1.3.0 the chassis ID number is 0 or 31. To view a unit’s ID
number, use the SYSTEM SHOW CLUSTER command.
For instructions, refer to “SYSTEM SHOW CLUSTER” on
page 88.
Privilege Levels
Administrator and read-write.
Description
This command resets all the modules, both media converter and
management, in a chassis by initializing the modules’ AT-S85 and AT-S97
Management Software. You might reset a chassis if you are experiencing
a problem with its modules.
Note
Resetting a media converter module may result in the loss of some
network traffic.
Note
When reset, the management module will be unresponsive to
commands for approximately one minute while it initializes the
AT-S97 Management Software.
Note
When reset, a media converter module immediately resumes
forwarding network traffic through its ports and channels using its
default settings while it initializes its AT-S85 Management Software,
a process that takes approximately one minute to complete. The
module will be unresponsive to management commands during the
initialization process. At the completion of the process, the module
configures its ports and channels according to the settings in the
active master configuration file on the management module.