Allied Telesis AT-S97 - Manual (Page 200)

Chapter 13: Diagnostics Commands
200
Figure 40. DIAGNOSTICS SHOW MODULE Command
The fields in the display are defined here:
ˆ Name - The name of the module. Refer to “SYSTEM SET MODULE”
on page 77 for instructions on assigning a name to a module.
ˆ Model - The model name.
ˆ MAC - The module’s MAC address.
ˆ SN - The module’s serial number.
ˆ HW Rev. - The module’s hardware revision level.
ˆ Software Version - The version number of the AT-S85 or AT-S97
Management Software.
ˆ Voltages - Input voltages on the module.
ˆ Temperature - The current temperature of the module.
ˆ Temperature Threshold - The temperature threshold of a module. The
management module logs an event in the event log if the threshold is
exceeded, to warn of possible excessive temperature in the wiring
closet or chassis. Refer to “SYSTEM SET MODULE” on page 77 for
instructions on setting a module’s temperature threshold.
Eeprom Information
Name .......................
Model ...................... AT-MCF2012LC
MAC ........................ 00:15:77:70:7A:22
SN ......................... 14
HW Rev ..................... 1
CPU Software Information:
Software Version ........... v1.3.0
CPU Information:
Name .......................
Module Type ................ AT-MCF2012LC
Module Status .............. Active
Module Present ............. Present
1.2V ....................... Good = 1.198
1.8V ....................... Good = 1.804V
2.5V ....................... Good = 2.509
3.3V ....................... Good = 3.302V
12.0V ...................... Good = 12.6224
Temperature ................ 38.15V
Temperature Threshold ...... 60 C