Allied Telesis AT-S97 - Manual (Page 144)

Chapter 8: Configuration File Commands
144
Description
This command creates a new master configuration file with the current
parameter settings of the modules in the chassis. The file is stored in the
file system on the management module. For background information, refer
to “Overview” on page 130.
If, after creating a new master configuration file, you want to designate it
as the active file on the management module, perform the CONFIG SET
command. For instructions, refer to “CONFIG SET” on page 145.
Example
This command creates the new master configuration file “mcf pat
traffic.cfg” with the current settings of all the modules in the chassis or
stack. The chassis with the management module has the ID 0:
config save filesystem=system://0/m/"mcf pat traffic.cfg"