Allied Telesis AT-S97 - Manual (Page 61)

61
Chapter 5
Port and Module Commands
This chapter contains the following sections:
ˆ “Overview” on page 62
ˆ “SYSTEM RESET CHASSIS” on page 64
ˆ “SYSTEM RESET CLUSTER” on page 66
ˆ “SYSTEM RESET MODULE” on page 68
ˆ “SYSTEM SET INTERFACE” on page 71
ˆ “SYSTEM SET MODULE” on page 77
ˆ “SYSTEM SET PORT” on page 80
ˆ “SYSTEM SHOW CHASSIS” on page 86
ˆ “SYSTEM SHOW CLUSTER” on page 88
ˆ “SYSTEM SHOW INTERFACE” on page 90
ˆ “SYSTEM SHOW MODULE” on page 97
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
8, “Configuration File Commands” on page 129.