Allied Telesis AT-S97 - Manual (Page 127)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
127
Port # Mode Set to
A channel’s operating mode was changed to
Link Test, Missing Link, or Smart Missing
Link. “Port #” refers to the channel number.
For example, the message “Port 1 Mode Set
to Smart MissingLink” signals that channel 1
on a media converter module was set to the
Smart MissingLink mode. Report
Event Level Messages
SSH Server Disabled The SSH server, used for remote
management of the chassis or stack with an
SSH client, was disabled with the SSH
DISABLE command. Report
SSH Server Enabled The SSH server was enabled with the SSH
ENABLE command. Report
SSH Session Close A remote SSH client ended a management
session with the management module. Report
SSH Session Open A remote SSH client established a
management session with the management
module. Report
Telnet Server Disabled The Telnet server, used for remote
management of the chassis or stack from a
Telnet client, was disabled with the TELNET
DISABLE command.
Report
Telnet Server Enabled The Telnet server was enabled with the
TELNET ENABLE command. Report
Telnet Session Open A remote Telnet client established a
management session with the management
module. Report
Telnet Session Close A remote Telnet client ended a management
session with the management module. Report
TFTP Session Open The management module uploaded or
downloaded a file during a local or remote
management session using TFTP. For
example, you would see this message if you
downloaded new management software onto
the modules using TFTP. Report
TFTP Session Close The management module completed
uploading or downloading a file to a TFTP
server. Report
Table 11. Event Messages (Continued)
Message Definition Classification