Allied Telesis AT-S97 - Manual (Page 77)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
77
SYSTEM SET MODULE
Syntax
system set module id= chassis / slot name= name
temperature-threshold= value
Parameters
id Specifies a module in the chassis. The command can
configure only one module at a time. The ID consists of the
following parts:
chassis Specifies the ID number of the chassis. In
version 1.3.0, the chassis ID number is 0 or 31.
slot Specifies the number or letter of the chassis slot
with the module. Possible values are:
m Identifies the management module
slot.
1 or 2 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2 when the unit
is viewed from the front.
a or b Specifies a slot letter of a power
supply or fan module. In the
AT-MCF2000 Chassis, the left slot is
A and the right slot is B when the unit
is viewed from the back.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 88 or “SYSTEM
SHOW CHASSIS” on page 86.
name Assigns a name of up to 20 alphanumeric characters to the
module. Spaces are permitted, but a name with spaces
must be enclosed in double quotes (“ “). To remove the
current value without specifying a new value, enter “none”.
To view the current name of a module, refer to “SYSTEM
SHOW INTERFACE” on page 90, “SYSTEM SHOW
CHASSIS” on page 86 or “SYSTEM SHOW CLUSTER” on
page 88.