Allied Telesis AT-S97 - Manual (Page 69)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
69
Note
When reset, a management module will be unresponsive to
commands for approximately one minute while it initializes the
AT-S97 Management Software.
Note
When reset, a media converter module immediately resumes
forwarding network traffic through its ports and channels using its
default settings while it initializes its AT-S85 Management Software,
a process that takes approximately one minute to complete. The
module will be unresponsive to management commands during the
initialization process. At the completion of the process, the module
configures its ports and channels according to the settings in the
active master configuration file on the management module.
Note the following before performing this command:
ˆ This command can reset only one module at a time.
ˆ This command can reset the management module or a media
converter module. It cannot reset a power supply or fan module, or the
AT-MCF2000S Stacking Module.
ˆ Resetting the AT-MCF2000M Management Module ends your
management session. To continue managing the chassis, you must
reestablish the session after the module has completed initializing its
software. The process takes about one minute.
ˆ Resetting the AT-MCF2000M Management Module does not affect the
media converter modules in the chassis.
ˆ If you are resetting a media converter module, you can use the
SYSTEM SHOW CLUSTER or SYSTEM SHOW CHASSIS command
to determine when the module has completed the initialization
process.
ˆ To reset all of the media converter modules in a chassis with just one
command, use the SYSTEM RESET CHASSIS command. For
instructions, refer to “SYSTEM RESET CHASSIS” on page 64.
Examples
This command resets the media converter module in slot 2 in a chassis
with the ID number 0:
system reset module id=0/2
This command resets the AT-MCF2000M Management Module:
system reset module id=0/m