Allied Telesis AT-S97 - Manual (Page 81)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
81
port Specifies the letter of a port in a channel on a
media converter module. Possible values are:
a Specifies the twisted pair port.
b Specifies the fiber optic port
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 88 or “SYSTEM
SHOW CHASSIS” on page 86. To view the ports of a
channel, refer to “SYSTEM SHOW INTERFACE” on
page 90.
port-state Enables and disables the port. Available settings are:
enable Activates the transmitter and receiver on the
port. This is the default setting.
disable Deactivates the transmitter and receiver on the
port.
auto-neg Activates and deactivates IEEE 802.3u Auto-Negotiation
and auto-MDI/MDIX on a port. When Auto-Negotiation is
activated, the port’s speed, duplex mode, and wiring
configuration are set automatically. Available settings are:
enable Activates IEEE 802.3u Auto-Negotiation and
auto-MDI/MDIX on the port. This is the default
setting for a twisted pair port. This is also the
default setting for fiber optic ports that support
Auto-Negotiation, such as 100Base-SX ports.
This setting is not appropriate for fiber optic
ports that do not support Auto-Negotiation, such
as 100Base-FX and 1000Base-F.
disable Deactivates IEEE 802.3u Auto-Negotiation and
auto-MDI/MDIX on the port.
speed Sets the speed of a twisted pair port. Available settings are:
10 Sets the speed of the port to 10 Mbps.
100 Sets the speed of the port to 100 Mbps.
1000 Sets the speed of the port to 1000 Mbps. This
setting is applicable to the 10/100/1000Base-T
port on the management module. This setting is
not supported on the twisted pair and fiber optic
ports on the AT-MCF2012LC and
AT-MCF2012LC/1 Media Converter Modules.