Allied Telesis AT-S97 - Manual (Page 141)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
141
CONFIG RUN
Syntax
config run
Parameters
None.
Privilege Levels
Administrator and read-write.
Description
This command configures the parameters settings on the modules in the
chassis according to the settings in the active master configuration file on
the management module. This command is typically used to configure the
modules after you have designated a new active master configuration file
on the management module. Here is the sequence of the commands to
this function:
1. Designate a new active master configuration file for the chassis using
the CONFIG SET command. For instructions, refer to “CONFIG SET”
on page 145.
2. Configure the settings on the modules according to the settings in the
file by performing this command.
This command is also useful if you configured the parameters of the
modules but did not save them, and want to discard the charges and
return to the original configuration of the modules. For example, perhaps
you modified but did not save the settings of the ports on a media
converter module, and want to discard the changes.
The result of this command is similar to the SYSTEM RESET CHASSIS
command or power cycling the unit. The difference is that with this
command the management software on the modules is not initialized,
making for a faster reset and configuration of the modules. A reset or a
power cycle of a chassis can take upwards of one minute to complete
while the modules initialize their management software. This command, on
the other hand, is much faster and is typically completed in just a few
seconds.
Example
config run