Allied Telesis AT-S97 - Manual (Page 96)

Chapter 5: Port and Module Commands
96
Disabled - The port was disabled with SYSTEM SET PORT command.
For information, refer to “SYSTEM SET PORT” on page 80.
ˆ Link Status - The status of the link of a port to its network device. For
definitions, refer to Table 4, “Port Status in the Link Test Mode” on
page 93, Table 5, “Port Status in the MissingLink Mode” on page 93, or
Table 6, “Port Status in the Smart MissingLink Mode” on page 93.
ˆ Auto Negotiation - A status of Enabled is an indication that the twisted
pair port’s speed, duplex mode, and MDI/MDI-X wiring configuration
are set automatically with Auto-Negotiation and the auto-MDI/MDI-X
feature. A status of Disabled means the port’s speed, duplex mode,
and MDI/MDI-X wiring configuration were set manually.
ˆ Speed - The speed of the port when the parameter is set manually.
This parameter does not reflect the actual current speed when a port is
using Auto-Negotiation.
ˆ Duplex - The duplex mode of the port when the parameter is set
manually. This parameter does not reflect the actual current duplex
mode when a port is using Auto-Negotiation.
ˆ MDI Crossover - The wiring configuration of the twisted pair port.
ˆ Ingress and Egress Rate Limits - The settings for the packet filtering
feature. For information, refer to “SYSTEM SET PORT” on page 80.
To configure the channels and ports of a media converter module, refer to
“SYSTEM SET INTERFACE” on page 71 and “SYSTEM SET PORT” on
page 80.
Examples
This command displays a list of the media converter modules in a chassis
with the ID number 0:
system show interface id=0
This command displays a list of the media converter modules in a chassis
with the ID number 31:
system show interface id=31
This command displays the status of all the channel ports on a media
converter module in slot 2 of a chassis with the ID number 0:
system show interface id=0/2
This command displays the parameter settings for the two ports of
channel 11 of a media converter module in slot 1 of a chassis with ID
number 0:
system show interface id=0/1/11