Allied Telesis AT-S97 - Manual (Page 101)

101
Chapter 6
Network Time Protocol Commands
This chapter contains the following sections:
ˆ “Overview” on page 102
ˆ “NTP DISABLE” on page 104
ˆ “NTP ENABLE” on page 105
ˆ “NTP SET” on page 106
ˆ “NTP SHOW” on page 107
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
8, “Configuration File Commands” on page 129.